SVP 450 PLUS - SVD 500 PLUS
All peaking, hue, colour, brightness and contrast values are now stored.
To recall the SET adjustment, press 
, no message is displayed.
To change the USER adjustment: change according to the peaking, hue, colour, brightness and contrast required.
To store a set of adjustments that will be used by the projector at switching on: use peaking, hue, colour brightness and contarst value to reach a personalized adjustment.
To store the adjustments carried out, press the MEMO menu.
The user setup is stored only when the MEMO button is pressed and one of the adjustments is switched on (a small window appears showing a digit that disappears in a few seconds).
To change the video picture adjustments.
For instance, to change the contrast value, press 
for 1 second only, the screen displays the following indication:
CON 49
Increase or decrease the value by means of the arrows 
until the desired value is reached.
To store the new value within the USER adjustments, press the button MEMO, the remote control shows the following:
STORED | CON 49 |
Press ESC to let the message disappear or wait 4 seconds and it will disappear on its own.
3.19 Installation menu
The adjustments described in this paragraph must be carried out by qualified personnel. Any adjustments incorrectly done can cause deterioration in picture quality.
3.20How to enter the installation mode
It is only possible in the installation mode to change deflection, adjust the white balance, turn ON/OFF the comb. filter, choose the type of installation and store a setting in the memory banks.
Besides carrying out all user adjustments, with the same RC 3100 user remote control it is also possible to carry out all adjustments for a perfect installation and a proper setting of relevant parameters.
In order to prevent the final user from gaining access and carrying out unnecessary installation adjustments, the projector is equipped with a special protection key. Observe the following procedure to unlock it and gain access to the installation mode.
Press the button • • • for 2 seconds. The following menu appears:
MAIN SETTINGS
MEMO NOR DATA
INSTALL. MENU
Press the arrows 
to select MENU INSTALL.
Press the button EXIT seven times, until the following menu is displayed:
INSTALL MODE
Before adj. REGISTRATIONS be sure the following items have been checked :
1Mechanical centering of the projector and tubes
2Lens focus adjustment
Press the button ENTER.
The following menu appears:
INSTALL MODE
DEFLECTION
VIDEO SETUP
OPTIONS
PATTERN SELECT
Use the arrows 
to select each single menu item. Each line corresponds to a
Note: The following menus operate only in the installation mode: deflection; video param.; options and test patterns. Further details about these menus can be found in the section of this manual relevant to installation.
Once the installation procedure is through, switch off the projector to exit the installation mode, finally
14
