SVP 450 PLUS - SVD 500 PLUS
12 TROUBLESHOOTING
The LED lights on the rear panel shows the projector status.
|
|
|
| SH |
| LED Lights | MEANING |
| |
|
| NGLI | ||
|
|
|
| |
ON indicator | Red light |
| ||
|
|
|
| E |
| Green light | Normal operation |
| |
|
|
| ||
|
| |||
|
|
|
|
|
Remote control |
| The projector is |
|
|
indicator | Intermittent light | receiving a command |
|
|
|
| from remote control |
|
|
|
|
|
|
|
In case of malfunction, before calling in a technician check the following table:
PROBLEM | CAUSES | REMEDY | |
|
|
| |
| The ON push button has not been | Press the ON button | |
| pressed | ||
The projector will not turn on |
| ||
The power cable is disconnected | Connect the power cable | ||
| |||
|
|
| |
|
| If the LED is red it means the | |
No picture is displayed on the screen | The projector is switched off | projector is on | |
| numerical key to switch it on. | ||
| The input setting is wrong | Ref. INPUT SELECTION | |
|
|
| |
The picture is not properly displayed | The picture setup is wrong | Ref. PICTURE ADJUSTMENT | |
on the screen |
| ||
|
| ||
|
|
| |
The message Fan Protection | One or more fans have stopped | Check that the cooling fan ventilation | |
Detected switch off in 06 seconds | |||
holes are not clogged | |||
| |||
appears on the screen |
| ||
|
| ||
|
|
| |
The message ERROR ON | A communication error has been | Switch the projector off and then back | |
on again. If the message persists | |||
board xxx device xxx | detected | ||
contact a qualified technician | |||
appears on the screen |
| ||
|
| ||
|
|
| |
The message Convergence | Overcurrent has been detected | Reset the current memory bank and | |
Overload | repeat installation. | ||
on the convergence board | |||
appears on the screen | If the message persists contact a | ||
| |||
| qualified technician | ||
|
| ||
During normal operation the projector | The projector is in the | Ask for service | |
switches off | PROTECTION MODE |
| |
|
|
|
41