i n t e l l i g e n t

w i r e l e s s

p l a t f o r m

Figure 2-27 Changing Remote Router/NAT to Remote Bridge

2.6.6 Remote Bridge to Remote Router/NAT

Follow the steps below to change Remote Bridge mode to Remote Router/NAT mode

1Go to Tools System Configuration drop down menu. The System Configuration will be displayed as shown below.

2Alternatively, click on the current device mode link on the top right hand corner to go to the System Configuration page.

3Click on “Current Operational Mode”, Select the Radio that has to be configured as Remote Router/NAT and click on Apply Changes. A confirmation pop-up window will be displayed.

4Enter IP Address, IP Mask for Ethernet Configuration, and the IP Address, IP Mask and Gateway for the Wireless configuration. By default the DHCP is disabled and can be enabled if required.

5Click on the Apply Changes button to change the settings. The device will be rebooted and set to the chosen operational mode.

airHaul2 Nexus PRO™ User Guide

Page 40 of 113

 

Page 40
Image 40
SmartBridges sB3021 manual Remote Bridge to Remote Router/NAT, Changing Remote Router/NAT to Remote Bridge