SmartBridges sB3021 manual Dual Radio Configuration, Root Bridge to Remote Bridge

Models: sB3021

1 113
Download 113 pages 40.75 Kb
Page 32
Image 32

i n t e l l i g e n t

w i r e l e s s

p l a t f o r m

2.6Dual Radio Configuration

In the Repeater mode, the two radios in the airHaul2 Nexus PRO are configured as Root and Remote. The configuration allows the user to configure the airHaul2 Nexus PRO unit as Root Bridge, Remote Bridge or Remote Router/NAT mode.

By default, airHaul2 Nexus PRO unit is set to Repeater Mode and one radio acts as Root Bridge and the other radio as Remote Bridge.

2.6.1 Root Bridge to Remote Bridge

Follow the steps below to change from Root Bridge mode to Remote Bridge mode:

1.Go to Tools System Configuration drop down menu. The System Configuration will be displayed as shown below.

2.Alternatively, click on the current device mode link on the top right hand corner to go to the System Configuration page.

3.Click on the Current Operational Mode, select the radio that has to be configured as Remote Bridge and click on Apply Changes. A confirmation pop-up window will be displayed.

4.Enter IP Address, IP Mask and Gateway for Ethernet Configuration. DHCP is disabled by default and can be enabled if required.

5.Click on the Apply Changes button to change the settings. The device will reboot and be set to the chosen operational mode.

airHaul2 Nexus PRO™ User Guide

Page 32 of 113

 

Page 32
Image 32
SmartBridges sB3021 manual Dual Radio Configuration, Root Bridge to Remote Bridge