i n t e l l i g e n t

w i r e l e s s

p l a t f o r m

2.6.5 Remote Router/NAT to Remote Bridge

Follow the steps below to change Remote Router/NAT mode to Remote Bridge Mode:

1Go to Tools System Configuration drop down menu. The System Configuration will be displayed as shown below.

2Alternatively, click on the current device mode link on the top right hand corner to go to the System Configuration page.

3Click on “Current Operational Mode”, select the radio that has to be configured as Remote Bridge and click on Apply Changes. A confirmation pop-up window will be displayed.

4Enter IP Address, IP Mask and Gateway for Ethernet Configuration. DHCP is disabled by default and can be enabled if required.

5Click on the Apply Changes button to change the settings. The device will be rebooted and set to the chosen operational mode.

Figure 2-26 System Configuration Page--Remote Router/NAT to Remote Bridge

airHaul2 Nexus PRO™ User Guide

Page 39 of 113

 

Page 39
Image 39
SmartBridges sB3021 manual Remote Router/NAT to Remote Bridge