SMC Networks SMC6826MPE manual Connecting to a Power Source, Power Socket

INSTALLING THE SWITCH

Connecting to a Power Source

To connect a switch to a power source:

1.Insert the power cable plug directly into the AC socket located at the back of the switch.

100-240V~ 50/60Hz 8.0-2.0A

Figure 3-8 Power Socket

2.Plug the other end of the cable into a grounded, 3-pin socket, AC power source.

Note: For international use, you may need to change the AC line cord. You must use a line cord set that has been approved for the socket type in your country.

3.Check the front-panel LED indicators as the device is powered on to be sure the PWR LED is lit. If not, check that the power cable is correctly plugged in.

4.If you have purchased a Redundant Power Supply, connect it to the device and to an AC power source now, following the instructions included with the package.

3-12