Snapper IS1500Z, IS2000Zc manual Mower Deck Preparation, Installation

Mower Deck Preparation

IS1000Z Series (52” Model):

B A

1. Loosen the spring compression nut (B, Figure 17) to release the belt tension.

2. Slide the drive belt over the edge of the idler pulley and then remove the belt from the right- hand (discharge side) spindle pulley.

Figure 17. Mower PTO Belt

A. Belt Tension Spring

B. Spring Compression Nut

IS2000Z Series (52” Model):

1.Using a 1/2” breaker bar, place the square end in the square hole located in the end of the idler arm (A, Figures 18). Carefully rotate the breaker bar counter-clockwise, which will relieve the tension on the belt exerted from the idler arm.

2.Slide the drive belt over the edge of the stationary idler pulley (B). Carefully release the tension on the breaker bar. Remove the belt from the right- hand (discharge side) spindle pulley.

1000Z Series (61” Model), IS2000Z Series (61”

Model), IS3000Z Series & IS3100Z Series, S150X

Series:

1.Using a 1/2” breaker bar, place the square end in the square hole located in the end of the idler arm (A, Figures 19). Carefully rotate the breaker bar counter-clockwise, which will relieve the tension on the belt exerted from the idler arm.

2.Slide the drive belt over the edge of the stationary idler pulley (B). Carefully release the tension on the breaker bar. Remove the belt from the right- hand (discharge side) spindle pulley.

A

B

Figure 18. Mower PTO Belt

A.Idler Arm

B.Stationary Idler Pulley

B A

Figure 19. Mower PTO Belt

A.Idler Arm

B.Stationary Idler Pulley

13

GB

Installation