Snapper IS1500Z, IS2000Zc manual Collector Installation, Install Collector Mount Plate, Esgb

Install Collector Mount Plate

(S150X & S200X Series)

1.Remove the carb. shield plate from top of the rear bumper.

2.Install the collector mount plate (A, Figure 40) and mount tabs (B) on to the bumper. Install the 3/8- 16 x 1-1/4” bolts (C) and 3/8” SAE washers (F) through the mount tabs and loosely secure with the 3/8-16 nylock flange nuts (E).

3.Install the 3/8-16 x 1” bolts (D) and 3/8” SAE washers (F) through the bottom mounting holes and loosely secure with the 3/8-16 nylock flange nuts (E).

4.Tighten the bottom mounting bolts securely.

5.Temporarily install the collector mount posts (A, Figure 41) into the collector plate and install the hitch pins (B). This will insure that the holes are properly aligned for easy installation and removal.

6.Tighten the top mounting bolts (C, Figure 37) securely and remove the hitch pins and mount posts.

Collector Installation

			C
			F
			D
	A		F
B			D
E
		E	B

Figure 40. Install Collector Mount Plate

A.Mount Plate

B.Mount Tab

C.3/8-16 x 1-1/4” Bolt

D.3/8-16 x 1” Bolt

E.3/8-16 Nylock Flange Nut

F.3/8” SAE Washers

A

B

Figure 41. Install Mount Posts & Hitch Pins

A.Mount Post

B.Hitch Pin

23

ESGB

Installation