Snapper IS2000Zc, IS1500Z manual Collector Installation, Install Collector Mount Plate

Installation

Collector Installation

Install Collector Mount Plate

(IS3000Z Series)

1.Install the collector mount plate (A, Figure 38) and mount tabs (B) on to the bumper. Install the 3/8- 16 x 2-3/4” bolts (C) through the mount tabs and loosely secure with the clamp bars (D) and 3/8-16 nylock flange nuts (F).

2.Install the 3/8-16 x 2-1/2” bolts (E) through the bottom mounting holes and loosely secure with the clamp bars (D) and 3/8-16 nylock flange nuts

(E).

3.Center mount plate on the bumper and tighten all the hardware securely.

4.Temporarily install the collector mount posts (A, Figure 39) into the collector plate and install the hitch pins (B). This will insure that the holes are properly aligned for easy installation and removal.

5.Tighten the top mounting bolts (C, Figure 38) securely and remove the hitch pins and mount posts.

A		D
			F
B
C
			D
E	C	B
		E

Figure 38. Install Collector Mount Plate

A.Mount Plate

B.Mount Tab

C.3/8-16 x 2-3/4” Bolt

D.Clamp Bar

E.3/8-16 x 2-1/2” Bolt

F.3/8-16 Nylock Flange Nut

A

B

Figure 39. Install Mount Posts & Hitch Pins

A.Mount Post

B.Hitch Pin

22 www.ferrisindustries.com