Installation
Blower Assembly
BLOWER ASSEMBLY
Preparing the Mower Deck (IS4500Z Models Only)
1.Loosen the
2.Loosen the 1/2” hardware that secures the idler pulley (G) to the idler arm assembly. Remove the idler pulley from the idler arm assembly. Discard the bolt that secured the idler pulley to the idler arm assembly.
3.Refer to figure 6. Install the new
4.Set the idler arm assembly aside for reinstallation later.
|
| F |
| G | E |
|
| |
| H |
|
| I | D |
|
| |
B |
|
|
A |
| J |
| C | |
|
| D |
Figure 5. Updating the Idler Arm Assembly
A.
B.3/8 Lock Washer
C.Idler Arm
D.9/16 Narrow Flat Washer
E.Idler Stud
F.
G.Idler Pulley
H.Idler Pulley Spacer, .52 X 1.00 X .44
I.Belt Keep
J.
5.Loosen the
6.Remove the
7.Refer to figure 6. Install the .41 X 1.75 X .14 washer (C) onto the bolt above the top of the blower assembly. Reinstall the belt keep (B) with the tab facing down, and secure with the
A |
B |
C |
D |
E |
F |
Figure 6. Installing the New Washer
A.
B.Belt Keep
C. .41 X 1.75 X .14 Washer
D.Fixed Idler Pulley
E.3/8” SAE Washer
F.
8 | www.ferrisindustries.com |