Remove the Rear Engine Shield
(IS3100Z with
1.If the engine is hot, allow sufficient time for the muffler to cool to prevent a burn injury during installation.
2.Remove the rear engine shield (C, Figure 35) from the top of the rear bumper (D) by removing the 3/8” hardware (A, B, & E) securing the shield to the bumper.
Install Collector Mount Plate
(IS3100Z Series with
1.Install the collector mount plate (A, Figure 36) on to the bumper. Install two of the
(C) over the top bumper tube and through the mounting plate and loosely secure with the
2.Install the remaining
3.Center mount plate on the bumper and tighten all the hardware securely.
Install Collector Mount Plate
(IS3100Z Series with
1.Install the collector mount plate (A, Figure 37) on to the bumper. Install two of the
(C)over the second tube down from the top of the bumper and through the mounting plate and loosely secure with the
2.Install the remaining
3.Center mount plate on the bumper and tighten all the hardware securely.
Collector Installation
A |
B |
C |
D |
E |
Figure 35. Remove the Rear Engine Shield
A.
B.3/8” Washers
C.Rear Engine Shield
D.Rear Bumper
E.3/8” Nylon Flange Nuts
A C
B |
Figure 36. Install Collector Mount Plate
A.Mount Plate
B.
C.
A C
B
Figure 37. Install Collector Mount Plate
A.Mount Plate
B.
C.
21
GB
Installation