Snapper IS2000Zc, IS1500Z manual Blower Assembly, Installation

Installation

Blower Assembly

Blower Assembly

1.Remove the existing 5/16-18 x 5/8” flange head bolts (B, Figure 9) from the blower housing (A).

2.Install the blower mount plate (C) onto the blower housing and reinstall the 5/16-18 x 5/8” flange head bolts. Tighten securely.

3.Install three (3) 3/8-16 x 1” bolts and nylon lock nuts (D) through the blower mount plate and blower. The bolt heads must be installed on the inside of the blower housing.

4.Loop the idler spring (A, Figure 10) through the 1/4” x 2” eyebolt (B). Install the eyebolt through the L-bracket on the blower mount and install the 1/4-20 nylock flange nut (C). Tighten the nut until the eyebolt contacts the L-bracket.

Note: For 52” decks, the spring anchor bolt (D) has to be reversed. So that the idler spring can be attached to anchor bolt above the idler arm (E).

A

B

B

C

D

Figure 9. Install Blower Mount Plate

A.Blower Housing

B.5/16-18 x 5/8” Bolts (existing)

C.Blower Mount Plate

D.3/8-16 x 1” Bolts & Nylon Lock Nuts (3X)

C

E

DA B

Figure 10. Install Idler Spring

A.Idler Spring

B.1/4” x 2” Eyebolt

C.1/4-20 Nylock Flange Nut

D.Spring Anchor Bolt

E.Idler Arm

10 www.ferrisindustries.com