8.Loosen the
(D) to the blower assembly. Remove the
9.Place the support plate (B) on the blower assembly. Line up the two rows of holes in the support plate with the two rows of holes on the blower assembly.
10.Refer to figure 7. Place a
(B)and secure with a 3/8-16 hex serrated flange nut (A).
11.Reassemble the adjustable idler pulley components as shown in Figure 7. Install the 3/8- 16 X
12.Using a 3/8” drill bit, drill a 3/8” hole through the blower assembly using the left rear hole (see Figure 7) as a guide.
13.Install a
14.Reinstall the idler arm assembly to the blower assembly as shown in Figure 8. Install the idler stud (A, Figure 8) down through a 9/16 narrow flat washer (B) then down through the idler arm assembly (C), then down through another 9/16 narrow flat washer (B), then down through the blower assembly, then down through the 3/8 lock washer (D), and secure with the
Blower Assembly
| A |
| B |
| C |
| Drill |
| Here |
Outer | Inner |
Row | Row |
| D |
| F |
| E |
| G |
| H |
Figure 7. Installing the New Support Plate
A.
B.Support Plate
C.
D.Adjustable Idler Pulley
E.3/8” SAE Washer
F. .39 X .75 X .38 Spacer
G.Belt Keep
H.
A |
C |
B |
D |
E |
B |
Figure 8. Updating the Idler Arm Assembly
A.Idler Stud
B.9/16 Narrow Flat Washer
C.Idler Arm Assembly
D.3/8 Lock Washer
E.
9
GB
Installation