Install Weight Mount Rack
1.Measure and mark the front main frame tubes to the dimensions shown in Figure 48.
2.Using a 3/8” drill bit, drill one (1) hole in each of the main frame tubes from the outside surface of the tube.
3.Slide the weight mount rack into the main frame tubes and align with the holes drilled through the frame (see Figure 49). It may require you drive the arms into the frame tubes using a wooden block and hammer.
4.Finish drilling through the opposite wall of the frame tubes using the weight rack as a guide.
5.Install the 3/8” bolts from the inside of the frame rail and fasten securely with the nylon lock nuts.
6.Install the counter weights supplied with the grass collector on the weight mount rack (see Figure 50).
7.Install the weight retainer rod through the weight mount rack and secure with the hairpin clips (see Figure 50).
Weight Mount Installation
(IS3000Z Series & IS3100Z Series) |
5” |
(12,7cm) |
(3,18cm) |
Figure 48. Hole Location
Installation
Figure 49. Weight Rack Installation
Figure 50. Weight & Retainer Rod Installation
29
ESGB