Using SetupNavi and SetupLog

The SetupNavi function records a setting of the setup menu and setup files onto a tape, so that the same settings can be called up and used again or copied to another camera.

The SetupLog function records a camera setting every few seconds at shooting and displays the recorded data in the viewfinder during playback.

Note

The setup navigation function cannot be used with the RCP-TX7, RM-M7G, or CCU-M5A/M5AP connected. To use this function, disconnect the RCP-TX7, RM- M7G, or CCU-M5A/M5AP, power the camera off, and then power it on again.

Setting Up the Camera UsingData Recorded on Tape

The procedure to replace camera’s menu settings with settings recorded onto video tape is described here.

1 Insert the cassette onto which the data was recorded. Set the SETUP switch to FILE, then set the POWER switch to ON while holding down the MENU dial.

Advanced menu page 1 appears.

(The following figure shows an example for the DSR-570WS/570WSP.)

2 Turn the MENU dial until advanced menu page 14 (page 13 on DSR-370/370P) appears.

For details of menu operation, see “Advanced Menu Operations” (page 98).

”NO TAPE” is displayed if you neglected to load a cassette.

3 Move the cursor to RECALL DATA with the MENU switch to call up the data recorded on the tape. (Press the MENU switch to cancel.)

The tape is rewound and playback starts. The display changes as follows and the call up operation begins.

Name of data being called up

a)The model name DSR-570WS/570WSP or DSR-370/ 370P is displayed when a tape saved by one of those models is read. Nothing is displayed when a tape saved by previous models (DSR-500WS/500WSP, etc.) is read.

To abort the call up operation while in progress Press the MENU dial.

After the data has been read, the following display appears.

(Continued)

Menus and Indications Screen Viewfinder 4 Chapter

Chapter 4 Viewfinder Screen Indications and Menus 113