Note

The recording time displayed when this switch is set to TTL or DUR is obtained by counting the duration of the internal reference signal input to the camcorder. The value may not agree exactly with the value derived from the time code values. Furthermore, the value displayed may not be correct when another manufacture’s VCR is connected to the camcorder.

2SKIN DTL (skin detail) switch

Set this switch to ON to use the skin detail correction function.

For details, see “Skin Detail Correction” (page 138).

3EXT VTR OUTPUT switch

Depending on the external VCR connected to the VTR/CCU connector (0 on page 29), this switches the video signal output to the VCR.

COMPONENT, VBS: Component/composite video signal

Y/C: S-video signal

Note

When a CCU (camera control unit) is connected, component video signals/composite video signals are output, regardless of the setting of this switch.

4VTR TRIGGER switch

Sets the function of the VTR button on the camcorder or lens when a VCR is connected to the VTR/CCU connector (0 on page 29) or DV OUT connector (8 on page 29).

PARALLEL: Operates both internal and external VCRs.

INT ONLY: Operates the internal VCR only. External VCR operation is performed locally.

EXT ONLY: Operates the external VCR only. Set this switch to INT ONLY when you need to do cut editing or dubbing using the DV OUT connector.

5FRONT MIC LOW CUT switch

Set this switch to ON to insert a high-pass filter in the microphone circuit, reducing wind noise.

Normally leave the switch in the OFF position.

6SETUP switch

This selects the setup method for this camcorder. FILE: Set up using both a setup file and the setup

menu.

STD: Set up using the setup menu. The setup file is no longer displayed.

7HYPER GAIN switch

Setting this switch to ON increases the gain by a factor of about 60 with respect to 0 dB (a 30 dB increase by electronic amplification and a 6 dB increase for DPR, bringing about a total gain increase of 36 dB, or an increase 42 dB for the DSR-570WS/570WSP only). When this switch is in the ON position, the indication “HYPER” appears in the viewfinder, and the GAIN UP indicator in the viewfinder also lights.

When finished shooting, return this switch to OFF position. The “HYPER” indication disappears and the GAIN UP indicator goes out.

Note

Increasing the gain with this switch reduces the horizontal resolution by approx. 50%.

8SKIN DTL (skin detail ) SET button

Press this button with the SKIN DTL switch 2 to display the area detect cursor on viewfinder screen. Place the cursor on the target and press this button to perform skin detail correction.

For details, see “Skin Detail Correction” (page 138).

9TTL (total) RESET button

Pressing this button resets the total recording time (TTL selection) to 0.

Overview 1 Chapter

Chapter 1 Overview 25