The title is superimposed to the picture displayed on the viewfinder screen.
3 Start shooting.
4 To stop the title recording, press the MENU switch or MENU dial to clear the title display.
When using the CCU-M5A/M5AP Camera Control Unit When the CCU function switch is set to TITLE ON, the title display is given priority and the normal status display (see page 86) does not appear.
However, the status display does appear while you press the camcorder’s MENU switch up to the STATUS side and hold it there.
Press the MENU dial once.
2
Access basic menu page 9 (title display).
1
To record a title (basic menu page 9)

When “CHECK DIAG” is displayed

The “CHECK DIAG” indication appears in the status display area whenever the camcorder’s automatic self diagnostic function detects an abnormality. Access this page and perform error checking. (This page is displayed as basic menu page 1.)

“CHECK DIAG” will also be displayed if there is a problem on the sync signal input to the GEN LOCK IN connector. Input a proper sync signal and then perform error checking.

To perform error checking

Press the MENU dial.

The error checking performs on the digital signal processing (DSP) and memory circuits and the results are displayed.

When no error is detected, “OK” appears.

Example: If an abnormality is detected in the DSP circuit.

The error message “DIAG ERROR” appears when the normal indications are displayed. If this message appears, contact your Sony dealer.

Menus and Indications Screen Viewfinder 4 Chapter

Chapter 4 Viewfinder Screen Indications and Menus 97