5F.B (flange focal length) adjustment ring and F.B (flange focal length) fixing knob

F.B adjustment ring : To adjust the flange focal length, loosen the F.B fixing knob, then turn the ring. (See page 133.)

F.B fixing knob: Fixes the F.B adjustment ring.

6MACRO (close-up) ring

For close-up, turn this ring while holding the M button down. (See page 135.)

7ZOOM selector

This selects the mode of zoom operation.

SERVO: power zoom

MANU. (manual): manual zoom

8Zoom remote control connector (8-pin) Connect the optional Lens Remote Control Unit for remote control of zooming.

9VTR button

This button starts and stops recording on the VCR. Press it once to start recording, and once more to stop.

0Shtl button

Use this for shuttle shot function (see next page).

qa RET (return) button

This allows you to check the video signal.

When the internal VCR is in recording pause mode, press this button to review the last few seconds of the recording in the viewfinder (recording review). When an external VCR is connected, pressing this button connects the E-E video signal from the external VCR to the viewfinder while the internal VCR is recording or no tape is inserted in the internal VCR.

Note

The E-E video from an external VCR connected to the DV OUT connector cannot be displayed in the viewfinder.

When a CCU (camera control unit) is connected, you can view the return video from the CCU in the viewfinder.

For details, see “Playback — Checking Recorded Contents” (page 70).

qs Motorized zoom lever

Use this to carry out a power zoom. Pressing the lever harder increases the zoom speed.

W end: zoom toward wide angle

T end: zoom toward telephoto

qd Iris selector

This selects the mode of iris operation. (See page 134.)

A (automatic): automatic iris

M (manual): manual iris

qf Instant automatic iris adjustment button While using manual iris control, press this button to switch temporarily to automatic iris control setting. Automatic control is maintained as long as you hold the button down.

qg Dip switchs

These are used to make settings for shuttle shot function.

This section is normally covered by a rubber cap.

qh Iris gain adjustment trimmer

Use this to adjust the iris gain.

This section is normally covered by a rubber cap.

qj Shuttle memory position knob

Use this for the shuttle shot function (see next page).

Overview 1 Chapter

Chapter 1 Overview 33