z Additional information
Precautions
On safety
Do not put any foreign objects in the DC IN 6 V jack.
On power sources
•Use house current, lithium ion rechargeable battery, two LR6 (size AA) batteries, or car battery.
•For use in your house: Use the AC power adaptor supplied with this recorder. Do not use any other AC power adaptor since it may cause the recorder to malfunction.
Polarity of the plug
•The recorder is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the recorder itself has been turned off.
•If you are not going to use this recorder for a long time, be sure to disconnect the power supply (AC power adaptor, dry batteries, rechargeable battery, or car battery cord). To remove the AC power adaptor from the wall outlet, grasp the adaptor plug itself; never pull the cord.
•For use in the car: Use the
On heat build-up
Heat may build up in the recorder if it is used for an extended period of time. In this case, leave the recorder turned off until it cools down.
On installation
•Never use the recorder where it will be subjected to extremes of light, temperature, moisture or vibration.
•Never wrap the recorder in anything when it is being used with the AC power adaptor. Heat
On the headphones
Road safety
Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in many areas. It can also be potentially dangerous to play your recorder at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations.
Preventing hearing damage
Avoid using headphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce the volume or discontinue use.
Caring for others
Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate of the people around you.
On the MiniDisc cartridge
•Do not break open the shutter.
•Do not place the cartridge where it will be subject to light, extreme temperatures, moisture or dust.
On cleaning
•Clean the recorder casing with a soft cloth slightly moistened with water or a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzene as it may mar the finish of the casing.
•Wipe the disc cartridge with a dry cloth to remove dirt.
•Dust on the lens may prevent the unit from operating properly. Be sure to close the disc compartment lid after inserting and ejecting an MD.
