If the following error messages flash in the display window, check the chart below.
Error message | Meaning/Remedy |
BLANKDISC | •An MD with no recording on it is inserted. |
| b Insert a recorded MD. |
|
|
DISC ERR | •The recorder cannot read the disc (it's scratched or dirty). |
| b Reinsert or replace the disc. |
|
|
DISC FULL | •There is no more space to record on the disc (less than 12 |
| seconds available). |
| b Replace the disc. |
|
|
BUSY | •You tried to operate the recorder while it was accessing the |
| recorded data. |
| b Wait until the message goes out (in rare cases, it may take |
| |
|
|
NAME FULL | •You tried to enter more than 200 characters for a track or disc |
| name or the total characters entered in an MD is more than |
| 1700. |
| b Enter the characters within the limit. |
|
|
Hi DC in | •Power supply is too high (The supplied AC power adaptor or |
| the recommended car battery cord is not used). |
| b Use the supplied AC power adaptor or the recommended |
| car battery cord. |
|
|
HOLD | •The recorder is locked. |
| b Slide HOLD against the allow to unlock the recorder |
| (page 18). |
|
|
LOW BATT | •Batteries are weak. |
| b Charge the rechargeable battery or replace the dry |
| batteries (pages 24, 25). |
MEM OVER | •You tried to record when there is no indication in the display, |
| and the recorder is placed where it receives continuous |
| vibration. |
| b Put the recorder on the stable place, and start recording |
| again. |
|
|
NO COPY | •You tried to make a copy from a disc that is protected by the |
| Serial Copy Management System. You cannot make copies |
| from a digitally connected source which was itself recorded |
| using the digital connection. |
| b Use the analog connection instead (page 6). |
|
|
NO DISC | •You tried to play or record with no disc in the recorder. |
| b Insert an MD. |
|
|