Setting the Code for Preset Audio and Visual Components (continued)

4Aim the Commander at the component and press the 1 key.

When the remote control signal is sent,is shown on the display.

If it successfully works (power-off for TV, power-on for VCR, DVD, SAT, CBL, AMP, and playback for CD, MD, TAPE), go to Step 5.

If it does not, repeat Steps 3 and 4.

5Press the ENTER key.

A beep sounds, and the code number and “ENTER” appear twice.

Note

It is recommended to write down the code number.

6Press COMMANDER OFF.

To check which code number is set

Press the DISPLAY key in Step 2 and 5. The code number and “ENTER” appear twice.

Be sure to press the DISPLAY key after you have pressed the ENTER key to set the code number. If you press the DISPLAY key before the code number is set, it returns back to the first number at which you started searching.

12GB