If you have problems setting up or using the Remote Commander, first check the batteries (page 6), then check the items below.
Symptom |
| Remedy | |||||
You cannot operate the | • Go closer to the component. The maximum operating distance is | ||||||
components. | approximately 32.8 ft. (10 m). | ||||||
|
| • Check that you are aiming the Commander directly at the compoent, | |||||
|
| and that there are no obstructions between the Commander and the | |||||
|
| component. | |||||
|
| • Turn on the components first, if necessary. | |||||
|
| • Check that the component has infrared remote capability. For example, | |||||
|
| if your component did not come with a remote commander, it probably | |||||
|
| is not capable of being controlled by a remote commander. | |||||
|
| • You have assigned a different component to the Component Select | |||||
|
| button. Check the component assigned to that button and the | |||||
|
| component code. | |||||
|
| • If you do not use the commander for a long time, LCD panel response | |||||
|
| may become erratic. In this case, follow the procedure below: | |||||
|
| 1 While pressing COMMANDER OFF, press MENU and EXIT. | |||||
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| A bullet mark will appear in the bottom left of the LCD panel. | |||||
|
| 2 Press the next target that appears in the top right of the LCD panel. | |||||
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
| 3 Press the square that appears in the centre of the LCD panel. | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
A beep sounds to confirm the setting.
Continued 55GB