Notes on learning the signals of an air-conditioner

About seasonal adjustments

If you change the settings of the air- conditioner for the season, you have to programme the remote control signals of the new settings on the Commander.

If the power-on/off operation does not work correctly

The air-conditioner may not be turned on or off properly with the button of this Commander, for which you have programmed its power-on/off signal.

If the Commander can operate only “ON” with one button and “OFF” with another, while your air-conditioner’s remote control can operate “ON/OFF” with a single button, programme the signal on two buttons of the Commander as follows.

1Clear the learned power-on/off signal. (In the example on page 36, clear the learned signal from the SYSTEM CONTROL B button.)

2Program the signal (transmitted from the power-on/off button of the air- conditioner’s remote control) for the SYSTEM CONTROL B button again.

3Program the signal from the same button of the remote control for another button (for example, the SYSTEM CONTROL C button).

The two buttons of the Commander have been programmed with the power-on signal and the power-off signal of the air- conditioner, respectively so that you can operate the air-conditioner with the Commander.

Transferring Data between Remote Commanders

You can transfer data, such as learned signals and component code settings, between this Commander and another Sony RM-AV2500T.

Transferring data

You can transfer the all data of this Commander or the data of a Component Select button on this Commander to another Sony RM-AV2500T.

To transfer the all data of the Commander

4

6

3

PROGRAM

 

2

TV

SAT

VCR

DVD

CBL

AMP

CD

MD

TAPE

M1

M2

M3

Continued 37GB