Transferring Data between Remote | 4 Press the 1 key. |
Commanders (continued) |
1Place the
Another remote commander
about 2 – 4 inches (5 – 10 cm) away
2While pressing COMMANDER OFF, press PROGRAM – and w
PROGRAM
3Press the R button.
R: Transfer data
r: Receive data
1:All data of the Commander
2:Data of a Component Select button
5Confirm that the receiving remote commander is ready for data.
(To set the receiving commander, follow the procedure on page 40.)
6Press the “ENTER” key.
As the data is transferred, the corresponding component name goes off. If the all data has been successfully transferred, the backlight of the display turns off.
Note
If “NG” appears while sending the data, go back to Step 5 and continue the operation or press COMMANDER OFF to stop the operation.
Note
Be sure that the receiving remote commander is ready to receive data.