Executing a Series of Commands
—System Control Functions (continued)
Example: To programme the procedure on page 22 for the VCR button
1While pressing COMMANDER OFF, press w + and VCR.
The selected component name stays lit, while other component names flash.
If a series of commands is already programmed for that button
The programmed operations are displayed in order. To programme a new series of operations, clear the programme first (page 25).
2Follow Steps 3 to 6 on page 24.
Notes
•You can programme the System Control functions for a Component Select button on which the
•You cannot programme the System Control functions for a Component Select button for which a signal has been programmed by “learning” (page 32). (“NG” flashes on the display.)
•You can programme a signal for a Component Select button by “learning” (page 32) for which the System Control functions have been programmed. In this case, the System Control function is overwritten and cannot be used. If you clear the “learned” signal on the button, the System Control function is resumed and you can use it again.
•You can programme the
•If you interrupt the procedure at any point for over two minutes, the setting mode ends and the series of commands will be programmed to that point. In this case, clear the programme and start again from Step 1 to set the entire programme from the beginning. You can not continue from where you let off.
•If you change the component code number (page 8) or programme a new signal by learning (page 15) for a key or button that has been programmed with the series of commands of a System Control function, the new signal will be transmitted when you press the corresponding Component Select button.