2While pressing COMMANDER OFF, press MUTING.

All the component names in the display flash.

3Press the Component Select button for the desired component.

The selected component remains displayed, and the 0 – 9, ENTER and DISPLAY keys flash.

4Press the four-digit component code number followed by the ENTER key on the touch-key display.

A beep sounds, and the code number and “ENTER” appear twice.

5If you want to set a code for another component, repeat Steps 3 and 4.

6Press COMMANDER OFF.

Notes

•If you press a component code number that is not on the table in the supplied “Component Code Numbers,” the Commander beeps and “NG” flashes after you press the ENTER key. If this happens, check the component code number, and try setting again.

•If you do not input anything into the Commander for over two minutes between each step, the setup procedure will be canceled. To set the code, you must press MUTING again while pressing

COMMANDER OFF.

•The first digit of the component code number means the component category (TV, VCR, etc.). The component corresponding to the four-digit component code number is preset in Step 4.

To check which code number is set

Press the DISPLAY key in Step 3 to 5. The code number and “ENTER” appear twice.

Continued 9GB