Programming a Frequently Used Key Operation for SYSTEM CONTROL Buttons (continued)
3Press the SYSTEM CONTROL button you want to teach.
“LEARN” flashes and the display for the pressed SYSTEM CONTROL key stays lit.
4Press and hold down the button of the remote control until you hear a beep.
(If you release the button before you hear a beep, the signal may not be learned correctly.)
“LEARN” display stops flashing and stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and 4 again.
5Press COMMANDER OFF.
Note
You can programme a remote control signal for a SYSTEM CONTROL button by “learning” for which the System Control functions have been programmed. In this case, the System Control functions are overwritten and cannot be used. If you clear the “learned” signal from the button, the System Control function, are restored, and you can use them again.
To clear the learned remote control signal
1While pressing COMMANDER OFF, press PROGRAM + and w +.
2While pressing the LIGHT button, press the SYSTEM CONTROL button (1 – 9, A, B, or C).
3Press COMMANDER OFF.
The display for that button flashes.
If you want to programme a new signal for that button, follow Steps 3 to 5.