Using Non-Preset Remote Control Operations

—Learning Function (continued)

The “C+ C- V+ V- MUTE RECALL MENU OK EXIT R r T t” display indicates if PROGRAM +/–, w +/–,

MUTING, RECALL, MENU, OK, EXIT and cursor (T t R r) buttons are learnable or not.

Note on the flashing display

The keys or buttons that are already preset for the component flash twice while those that are not preset flash once.

3Press the key or button on the Commander you want to “teach.”

“LEARN” flashes and the only pressed key remains on the dislplay.

To teach on the PROGRAM +/–,

w+/– , MUTING, RECALL, MENU, OK, EXIT and cursor buttons

Press the corresponding button. “LEARN” flashes, and only the pressed button remains indicated on the display (“C+,” “C–,” “V+,” “V–,” “MUTE,” “RECALL,” “MENU,” “OK,” “EXIT,” or “R r T t” ).

Example: When pressing the w + button

To change the function display of the key

Follow the procedure on page 18.

4Press and hold down the button on the other remote control until you hear a beep.

(If you release the button before you hear a beep, the signal may not be learned correctly.)

“LEARN” stops flashing and stays lit. When the command has been learned successfully, the learned keys stay lit and the other learnable keys flash.

If “NG” flashes on the display

Learning did not succeed. Try Steps 3 and 4 again.

5Repeat Steps 3 and 4 to teach functions to other keys or buttons.

To learn another component’s remote control signal

After positioning the two remote commanders as in Step 1 on page 15, press the corresponding Component Select button, and then follow Steps 3 and 4 on the left to perform learning.

6Press COMMANDER OFF.

16GB