To receive the data of a Component Select button from another remote commander

1~2 Perform Steps 1 and 2 on page 40.

3Press the 2 key.

4Press the Component Select button to which want to assign the data.

5Press the ENTER key.

When the data have been received, “TV” and “r” go off. If the data have been successfully received, the backlight of the display turns off.

Notes

•If the Commander is not ready for receiving the data, press CLEAR key, then OK key to clear the learned signal on all or one of the Component Select buttons.

•If “NG” appears during data transfer, go back to Step 3 and continue the operation or press COMMANDER OFF to stop the operation. If you continue the operation, you have to set the sending remote commander again to send data.

Selecting a Channel with a Single Key Press

— Channel Macro Function

You can programme the Channel Macro function for the keys listed below (macro keys).

If you programme the operation of entering the 1, 2, 3 and ENTER keys for a macro key, you can select the channel 123 by pressing that single key.

Component

Macro key

TV:

PIP STILL, PIP TEXT, PIP

 

CH+, PIP MOVE, PIP

 

SWAP, PIP CH-

CBL:

m, N, M, REC*, x, X

SAT:

m, N, M, REC*, x, X

*You can programme this function for REC key alone (not on the REC + B key for a double-key operation).

2

PROGRAM

1

5

TV

SAT

VCR

DVD

CBL

AMP

CD

MD

TAPE

M1

M2

M3

Continued 41GB