Others
The program detects the
Others
Using the Supplied Setup Program
To connect the camera to a network, you need to assign a new IP address to the camera when you installed the camera for the first time.
You can assign an IP address in two ways:
•Using the setup program stored in the supplied CD- ROM (see page 42)
•Using the ARP (Address Resolution Protocol) commands (see page 44)
This section explains how to assign an IP address to the camera using the supplied setup program and configure the network.
The setup program also allows the communication bandwidth setting and date and time setting.
Before starting, connect the camera to a computer or a local network, referring to “Assigning the IP Address to the Camera” in the supplied Installation Manual.
Assigning the IP Address Using the Setup Program
1 Insert the supplied
2
3
4 Install the IP Setup Program to your computer following the wizard displayed.
If the Software License Agreement is displayed, read it carefully and accept the agreement to continue the installation.
5 Start the IP Setup Program.
6 Click on the camera you want to assign a new IP address in the list.
The network settings for the selected camera are displayed.
7 Set the IP address.
To obtain the IP address automatically from a DHCP server:
Select Obtain an IP address automatically. The IP address, Subnet mask and Default gateway are assigned automatically.
To specify the IP address manually:
Select Use the following IP address, and type the IP address, Subnet mask and Default gateway in each box.
8 Set the primary DNS server address and, if necessary, secondary DNS server address.
To obtain the DNS server addresses automatically:
Select Obtain DNS server address automatically.
42
Using the Supplied Setup Program
