boxes are for the year (lower two digits), month, date, hour, minutes and seconds from left to right.
Using the computer’s date and time
The date and time set on the computer is displayed in the PC current date time setting box.
Click OK on the right to set the camera’s date and time to the displayed computer's date and time.
Note
Due to the network properties, there may be a slight difference between the displayed computer's date and time and those set on the camera.
Rebooting the Camera
Click Reboot on the Network tab to reboot the camera. It will take about 10 to 20 seconds to reboot.
Others
Assigning the IP Address to the Camera Using ARP Commands
This section explains how to assign an IP address to the camera using ARP (Address Resolution Protocol) commands without using the supplied setup program.
Note
Enter the ARP commands within 5 minutes after the power of the camera is turned on.
1 Open the DOS window on the computer.
2 Enter the IP address and the MAC address of the camera you want assign a new IP address to, using the following ARP commands.
apr
Example:
apr
3 When the following line is displayed on the DOS window, hold down Ctrl and press C.
Reply from 192.168.0.100:bytes=32 time...
You will normally receive the reply after about 5 repetitions of "Request time out."
Note
If you do not receive the reply, check the following:
–Did you enter the ARP commands within 5 minutes after the camera was turned on?
If not, turn off the camera and restart the operation.
–Is the NETWORK indicator on the camera flashing? If the indicator goes off, the network connection has a problem. Connect the network correctly.
–Did you enter the IP address previously used for another device?
Assign a new IP address to the camera.
–Do the computer and the camera have the same network address?
If not, set the same network address on the computer and the camera.
Sony Corporation
44 Assigning the IP Address to the Camera Using ARP Commands
