Tips
•Operations other than turning the receiver on or off are deactivated during auto calibration.
•When special speakers, such as dipole speakers are used, the measurements may not be performed correctly or auto calibration cannot be performed.
To confirm/save auto calibration when GUI function is turned off
1Confirm the measurement result.
When the measurement ends, a beep sounds and the measurement result appears on the display.
Measurement Display | Explanation | |
result |
|
|
|
|
|
When the | COMPLETE | Proceed to step |
measurement |
| 2. |
process |
|
|
completes |
|
|
properly |
|
|
|
|
|
When the | ERROR | See “Message |
measurement | CODE 3x | list after auto |
process fails |
| calibration |
|
| measurement” |
|
| (page 47). |
2Press V/v repeatedly to select the item,
then press .
The measurement results are saved.
Item | Explanation |
RETRY | |
| calibration. |
|
|
SAVE EXIT | Saves the measurement |
| results and exits the setting |
| process. |
|
|
WRN CHECK | Displays a warning |
| concerning the measurement |
| results. See “When you select |
| “WRN CHECK”” (page 47). |
|
|
PHASE INFO | Displays the phase of each |
| speaker (in phase/out of |
| phase). See “When you select |
| “PHASE INFO””. |
|
|
DIST.INFO | Displays the measurement |
| result for speaker distance. |
|
|
LEVEL INFO | Displays the measurement |
| result for speaker level. |
|
|