Inserting batteries into the remote

Insert two R6 (size-AA) batteries in the RM- AAP018 remote commander.

Observe the correct polarity when installing batteries.

RM-AAP018

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with old ones.

•Do not mix manganese batteries and other kinds of batteries.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

•When you replace the batteries, the programmed remote codes may be cleared. If this happens, program the remote codes again (page 112).

Tip

When the remote no longer operates the receiver, replace all the batteries with new ones.

About the command mode

The receiver and the remote use the same command mode.

If the command modes of the receiver and the remote are different, you cannot use the remote to operate the receiver.

If the command modes of both the receiver and the remote are those of the initial setting (AV SYSTEM 2), it is not necessary to reset them. You can switch the command mode (AV SYSTEM 1 or AV SYSTEM 2) of the receiver

36GB

and the remote. If both the receiver and the other Sony component respond to the same remote command, switch the command mode of either the component or the receiver to another command mode so that the component does not respond to the same remote command as the receiver.

To switch the command mode of the receiver

2CH/A.DIRECT

Turn on the receiver while pressing 2CH/A.DIRECT.

When the command mode is set to “AV2,” “COMMAND MODE [AV2]” appears on the display.

When the command mode is set to “AV1,” “COMMAND MODE [AV1]” appears on the display.

To switch the command mode of the RM-AAP018 remote

1 1

2

3

1Press ?/1 while pressing RM SET UP.

The RM SET UP button flashes.