Note

Depending on the characteristics of the sub woofer you are using, the setup distance value may be further away from the actual position.

Using the receiver as a pre- amplifier

You can use the auto calibration function when you use the receiver as a pre-amplifier.

In this case, the distance value shown on the display may differ from the actual distance value. However, there will be no problems even if you continue to use the receiver with that value.

1

2-7

Started Getting

Performing auto calibration

The auto calibration function allows you to measure the following:

•Speaker connectionsa)

•Polarity of speakers

•Speaker distanceb)

•Speaker sizeb)

•Speaker level

•Frequency characteristicsc)

a)This receiver corrects signals by analog downmix processing only for the center speaker and sub woofer when the multi-channel input is selected. The correction is invalid for other speakers.

b)The measurement result is not utilized when the multi-channel input is selected.

c)• DTS 96/24 signals are always played back as 48 kHz when you correct signals.

•The measurement result is not utilized in the following cases.

–The multi-channel input is selected. –“2ch Analog Direct” is being used.

–Input signals of which the sampling frequency is more than 96 kHz are being received.

1 Make sure that the AMP button is lit.

If it is not lit, or “GUI MODE” is not displayed in the display window of the receiver, follow the steps given in “7: Operating the receiver using the GUI (Graphical User Interface)” (page 37).

2 Press V/v repeatedly to select “Settings,” then press or b.

The Settings menu list appears on the TV screen.

3 Press V/v repeatedly to select “Auto Calibration,” then press or b.

4 Press V/v repeatedly to select “Quick Setup,” then press .

5 Press V/v repeatedly and to un-check the items you do not want to measure.

•Speaker Distance

•Speaker Level

continued

43GB