There is no sound from one of the front speakers.

•Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones. If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component. If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound.

•Make sure you have connected both the L or R jack to an analog component and not just to either the L or R jack. Use a monaural-stereo cable (not supplied). However, there will be no sound from the center speaker when a sound field (Pro Logic, etc.) is selected. When the center speaker is not connected, sound is output only from the front left/right speakers.

There is no sound from analog 2 channel sources.

•Check to make sure the selected audio (digital) input jack is not assigned to other inputs in “Input Assign” in the Input menu (page 93).

There is no sound from digital sources (from COAXIAL or OPTICAL input jack).

•Check that the INPUT MODE is not set to “Analog” (page 92).

•Check that the “2ch Analog Direct” is not being used.

•Check to make sure the selected audio (digital) input jack is not assigned to other inputs in “Input Assign” in the Input menu (page 93).

The source sound input from the HDMI jack is not output from an amplifier or the TV speaker connected to the receiver.

•Check that the component is connected correctly to the HDMI jack for that component.

•The sound is not output when you display the receiver’s menu on the TV monitor. Press AMP MENU to turn off the display.

•You can listen to the Super Audio CD on HDMI only by linear PCM signal transmission.

•Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.

The left and right sounds are unbalanced or reversed.

•Check that the speakers and components are connected correctly and securely.

•Adjust the balance parameters using the Auto Calibration settings menu.

There is severe hum or noise.

•Check that the speakers and components are connected securely.

•Check that the connecting cords are away from a transformer or motor, and at least 3 meters (10 feet) away from a TV set or fluorescent light.

•Move your TV away from the audio components.

•Make sure you have grounded the U SIGNAL GND terminal (only when a turntable is connected).

•The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.

There is no sound, or only a very low- level sound is heard from the center/ surround/surround back speakers.

•Select a “Cinema Studio EX” mode (page 61).

•Adjust the speaker level (page 67).

120GB