Sony STR-DG1100 Specifications, AUDIO POWER, Error messages, SPECIFICATIONS, Reference sections for clearing the memory

•Remove any obstacles in the path between the remote and the receiver.

•Replace all the batteries in the remote with new ones, if they are weak.

•Make sure that the command modes of the receiver and the remote are the same. If the command mode of the receiver and the remote are different, you cannot operate the receiver with the remote (page 36).

•Make sure you select the correct input on the remote.

•When you operate a programmed non- Sony component, the remote may not function properly depending on the model and the maker of the component.

Error messages

If there is a malfunction, the display shows a code of two numbers and a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.

PROTECTOR

Irregular current is output to the speakers, or the upper panel of the receiver is covered with something. The receiver will automatically turn off after a few seconds. Check the connection of the speakers and turn on the power again.

For other messages, refer to “Message list after auto calibration measurement” (page 47), “XM Radio message list” (page 85), “SIRIUS Satellite Radio message list” (page 85) and “DIGITAL MEDIA PORT message list” (page 90).

Reference sections for clearing the memory

To clear	See
All memorized settings	page 35

SpecificationsAUDIO POWERSPECIFICATIONS

POWER OUTPUT AND TOTAL

HARMONIC DISTORTION:

With 8 ohm loads, both channels driven, from 20 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output.

Amplifier section

POWER OUTPUT

Rated Power Output at Stereo Mode1) 2)
(8 ohms 20 Hz – 20 kHz,
THD 0.09%):
100 W + 100 W
Reference Power Output at Stereo Mode
(4 ohms 20 Hz – 20 kHz,
THD 0.15%):
85 W + 85 W
Reference Power Output
(8 ohms 1 kHz, THD 0.7%)
FRONT2):
110 W + 110 W
CENTER2): 110 W
SURROUND2):
110 W + 110 W
SURROUND BACK2):
110 W + 110 W
Reference Power Output
(4 ohms 1 kHz, THD 0.7%)	Additional
SURROUND2):
FRONT2):
100 W + 100 W
CENTER2): 100 W
100 W + 100 W	Information
1)Depending on the sound field settings and the
SURROUND BACK2):
100 W + 100 W
source, there may be no sound output.
2)Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz

continued

123GB