are output from the VIDEO jack. Input 480i component video signals.

When component input signals other than 480p are output, use the COMPONENT VIDEO OUT jack and set “Resolution” to “DIRECT.”

Images of the source with HDMI connection is not output to the TV.

Make sure that cables are correctly and securely connected to components.

Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.

Recording cannot be carried out.

Check that the components are connected correctly (page 25).

Select the source component using INPUT SELECTOR (page 49).

The GUI does not appear on the TV screen.

Press SHIFT, then press MENU to show “GUI MODE” on the display.

Check the TV is connected correctly.

Tuner

The FM reception is poor.

Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe.

Outdoor FM antenna (aerial)

Receiver

Ground (earth) wire (not supplied)

To ground

Radio stations cannot be tuned in.

Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.

Keep the satellite radio antenna, away from the speaker cords and the power cord to avoid picking up noise.

The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 77).

Press DISPLAY so that the frequency appears on the display.

The system cannot receive satellite channels at all.

The receiving condition is not good. Move the antenna to the place where the condition is good.

Check that you subscribed to the desired satellite radio service (see page 78).

Remote control

The remote does not function.

Point the remote at the remote sensor on the receiver.

122GB