Screws removed in step 1

CAC-12

3 Open the CAC-12 and remove the microphone adaptor.

Open the CAC-12.

Microphone adaptor 1)

Loosen the screw.

1)Attach the microphone adaptor when using a small-diameter external microphone.

4 Place an electret condenser microphone in the CAC- 12.

Note

When you detach the CAC-12 Microphone Holder once you have attached to the camcorder, be careful not to lose the two screws fixing the CAC-12. After detaching the CAC-12, be sure to put the two screws back into their original places (see the figure illustrating the step 1 operation).

8-5-3 Attaching a UHF Portable

Tuner (for a UHF Wireless

Microphone System)

To use a Sony UHF wireless microphone system, fit one of the following UHF portable tuners.

•WRR-855A/855B UHF Synthesized Tuner Unit

•WRR-862 UHF Portable Tuner.

For each of these UHF portable tuners, use the following attachment procedure.

For details, refer to the UHF portable turner manual.

Fitting the WRR-855A/855B

You can use the WRR-855A/855B UHF Synthesized Tuner Unit simply by inserting it into the slot in the camcorder, and fastening the fixing screws.

1 Undo the four fixing screws holding the cover of the slot, and remove the cover.

Close the CAC-12.

Tighten the screw.

m

ECM-672 or similar microphone

2 Insert the WRR-855A/855B, and fasten the four fixing screws.

Camcorder the Up Setting 8 Chapter

5 Connect the microphone cable to the AUDIO IN CH1 or AUDIO IN CH2 connector. Set the switches as described in the section "Switch settings when using an external microphone"(see page 120).

8-5 Audio Input System 121