
Camcorder the Up Setting 8 Chapter
Set the AUDIO IN switch (see page 120) to WIRELESS for the channel to be used.
For the operation of the
Notes
•When the XLR connection automatic detection function is on, even if the AUDIO IN
•The audio signals to be recorded on audio channels 3 and 4 depend on the settings of the AUDIO IN
1 (1) Attach the WRR tuner fitting (not supplied, service part number:
1Use a Phillips type screwdriver to tighten the four screws placed in the tuner fitting. For three of these screws, insert the screwdriver through the corresponding hole and tighten the screw.
2Loosen the adjustment screws.
3Adjust the tuner fitting position for a
4Attach the mount plate supplied with the
(2)Attach the battery pack.
For details about attaching the
Adjustment screws
Mount plate
(supplied with
Back of |
|
camcorder | Phillips type screwdriver |
|
2 Mount the tuner on the WRR tuner fitting.
3 Connect the tuner power cord to the DC OUT connector of the camcorder, and the audio output cable to the AUDIO IN CH1 or CH2 connector.
4 Set the switches as follows.
•Set the LINE / AES/EBU / MIC switch for the channel to which the audio out cable is attached to MIC.
•When the XLR connection automatic detection function is off, set the AUDIO IN
If the XLR connection automatic detection function is on, the input signal for audio recording is selected automatically, and therefore this setting is not required.
122