Item

Description

 

 

MONTH

Sets the month.

 

 

DAY

Sets the day.

 

 

5 Turn the MENU knob to move the b mark to the item you want to set, and press MENU knob.

The b mark on the left of the selected item changes to a z mark and the z mark on the left of the setting changes to a ? mark.

6 Turn the MENU knob to display the desired value, and press the MENU knob.

The z mark on the left of the selected item changes to a b mark and the ? mark on the left of the setting changes to a z mark.

7 To continue the remaining settings, repeat steps 5 and 6.

8 When you finish settings, turn the MENU knob to move the b mark to “OK”, then press the MENU knob.

The internal clock is set with the date and time set in steps 5 to 7. The TIME/DATE page of the DIAGNOSIS menu appears again. The time set on the TIME ADJUST setting window is displayed.

To cancel the setting

Before executing step 8, move the b mark to “ESC” at the top right of the window and press the MENU knob. Alternatively, push the CANCEL/PRST / ESCAPE switch down to the ESCAPE side.

All settings or changes are discarded and the TIME/DATE page of the DIAGNOSIS menu appears.

6-3-7 Selecting the Lens File

Note

When using a serial lens, lens file selection is not possible.

The LENS FILE page of the USER menu allows you to change the lens file according to the lens in use. Proceed as follows.

1 Set the MENU ON/OFF switch to ON.

The last accessed menu page appears on the screen.

2 Turn the MENU knob until the LENS FILE page appears, then press the MENU knob to select the page.

The LENS FILE page shows the name and the f-stop (iris setting) of the lens currently selected.

U15

LENS

FILE

TOP

LENS

FILE

SELECT:

1

F.ID

:

 

 

3 Turn the MENU knob to move the b mark to LENS FILE SELECT, and press the MENU knob.

The b mark on the left of the selected item changes to a z mark and the z mark on the left of the setting changes to a ? mark.

4 Turn the MENU knob until the lens file No. in use appears, then press the MENU knob.

The z mark changes to a b mark and the ? mark on the left of the lens No. changes to a z mark.

If you do not want to use a lens file

Select NO OFFSET.

5 To end the menu operation, set the MENU ON/OFF switch to OFF or close the cover of the menu operating section.

6-3-8 Selecting the Aspect Ratio

The FORMAT page of the OPERATION menu allows you to select the aspect ratio of the video output signal.

Note

When the CA-701/702/702P camera adaptor is used with the camcorder, this function is not available. To select the aspect ratio, disconnect the CA-701/702/702P camera adaptor from the camcorder or turn off the power of the CA-701/702/702P camera adaptor.

1 Follow the procedure of steps 1 to 3 described in 6-3-4 “Specifying an Offset for the Auto White Balance Setting” on page 96 to display the FORMAT page of the OPERATION menu.

20FORMAT

16:9/4:3 SELECT : 16:9

SCAN

MODE

:

I

UC/J

SELECT

:

UC

2 Turn the MENU knob to move the b mark to “16:9/4:3 SELECT”, and press MENU knob.

Settings Detailed and Displays Menu 6 Chapter

6-3 Adjustments and Settings from Menus

99