Speed Queen TMB796C 11

23.Remove laundry immediately after tumbler stops.

24.Always read and follow manufacturer’s instructions on packages of laundry and cleaning aids. Heed all warnings or precautions. To reduce the risk of poisoning or chemical burns, keep them out of reach of children at all times (preferably in a locked cabinet).

25.Do not tumble fiberglass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass.

26.Always follow the fabric care instructions supplied by the garment manufacturer.

27.Never operate the tumbler with any guards and/or panels removed.

28.DO NOT operate the tumbler if it is smoking, grinding, has missing or broken parts.

Safety Information

29.DO NOT bypass any safety devices.

30.Solvent vapors from dry-cleaning machines create acids when drawn through the heater of the drying unit. These acids are corrosive to the tumbler as well as to the laundry load being dried. Be sure make-up air is free of solvent vapors.

31.Failure to install, maintain, and/or operate this machine according to the manufacturer’s instructions may result in conditions which can produce bodily injury and/or property damage.

WARNING

To reduce the risk of serious injury, install lockable door(s) to prevent public access to rear of tumblers.

W055

M414905

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9

Contents

Page Page In the U.S.A In Canada In Australia WARNING •WHAT TO DO IF YOU SMELL GAS: –Do not try to light any appliance –Do not touch any electrical switch; do not use any phone in your building –Clear the room, building or area of all occupants Table of Contents Steam Requirements Single Drop Timer Rotary Coin Drop Timer Adjustments Removing Tumbler from Service Introduction Model Identification Introduction Customer Service Wiring Diagram Serial Plate Location Safety Information Save These Instructions Important Safety Instructions Page Specifications and Dimensions Cabinet Dimensions Exhaust Outlet Locations Gas Connection Locations Electrical Connection Locations Steam Connection Locations Installation Pre-InstallationInspection Location Requirements Position and Level the Tumbler Bolt-OnAngle Option Page To Reverse the Loading Door Page Page Before Placing Tumbler into Service Required for CE Models Only Installing CE Gas Drying Tumblers General Information Supply Burner Country Orifice Capacity Basic Configuration Specific Conversion Procedures NOTE: Blank burner orifices are Part No. M400995 Page Exhaust Requirements Layout Make-UpAir Venting Individual Venting Manifold Venting Page Station 8 in. (203 mm) Duct 10 in. (254 mm) Duct Page Gas Requirements Use pipe compound, resistant to actions of L.P. gas, on all pipe threads Gas Supply Pipe Sizing and Looping Equivalent Length 25 feet 50 feet 75 feet 100 feet High Altitude Burner Orifice Sizing Electrical Requirements Grounding Instructions For CE Models Only Service/Ground Location To Connect Electrical Service To The Tumbler Page Jumper Configuration Instructions Ferrite Ring Installation 50 Pound Gas and Steam Models 75 Pound Gas and Steam Models 50 and 75 Pound Electric Models Steam Requirements Piping Recommendations Thermal Oil Prep Steam Pressure PSI (bar) Minimum Pipe Diameter Steam Trap Size (Pounds Condensate/Hour) Single Drop Timer Power-UpMode Ready Mode Start Mode Run Mode Dipswitch Settings Coin Pulse (in Minutes) Rotary Coin Drop Timer Installing Accessory Timing Cam Removal of Existing Timing Cam Installation of New Timing Cam Adjustments Gas Burner Air Shutter Airflow Switch Gas and Electric Tumblers Page Loading Door Switch Loading Door Catch Drive Belt Nonreversing Models Reversing Models Page Page Removing Tumbler from Service