Speed Queen TMB796C Required for CE Models Only, Installing CE Gas Drying Tumblers, General Information, Natural Gas, ●Liquefied Petroleum (L.P.) Gas

Installation

Required for CE Models Only

Once machine is installed, please be sure to complete the following items:

●Review and verify machine operation with customer.

●Leave all literature and a signed Declaration of Conformity with customer.

●Review machine warranty information with customer.

●Apply warning sticker on front panel of machine, in language appropriate to country of sale (included in literature packet).

Installing CE Gas Drying Tumblers

WARNING

To reduce the risk of electric shock, fire, explosion, serious injury or death:

•Disconnect electric power to the tumbler before servicing.

•Close gas shut-off valve to gas tumbler before servicing.

•Close steam valve to steam tumbler before servicing.

•Never start the tumbler with any guards/ panels removed.

•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the tumbler is properly grounded.

W002

General Information

This information is to be used when installing gas tumblers in countries and/or on gases different than the machine’s factory configuration. Tumblers are supplied from the factory for operation on Natural Gas 1000 Btu/cu ft. (8914 kcal/m3), or L.P. Gas 2500 Btu/ cu ft. (22,250 kcal/m3),in the countries of GB/IE/PT/ ES/IT/GR/LU/CH. To install machines in any other country, or on any other gas, requires some level of modification.

Machines are built in two different configurations:

●Natural Gas – regulated/governor

●Liquefied Petroleum (L.P.) Gas – not regulated/ no governor

Machines configured for Natural Gas (regulator/ governor) may be converted to L.P. Gas (not regulated/ no governor) with block-open kit, Part No. M400763.

Serial plates supplied from the factory are configured for GB/IE/PT/ES/IT/GR/LU/CH. These instructions pertain to the situations when the country of use or gas supply is different than that on the serial plate.

Table 1 describes the different gases that are available in different CE countries, and how the machines need to be configured to operate with those gases. In the CE, there are Natural Gas configurations that do not allow for machine regulation and L.P. Gas configurations that must be regulated. For L.P. Gas, third family B/P at 50 mbar, order Regulated Natural Gas machines and convert according to Table 1.

M414905