Installation

Position and Level the Tumbler

Remove lint panel door, and unscrew the four shipping bolts (one at each corner). Remove tumbler from skid.

NOTE: Do not throw bolts away – they are the leveling legs.

Remove four nuts from the literature package, and screw one fully on to each leveling leg.

Screw the four leveling legs (bolts) back into the level adjusting fittings from the bottom.

Slide tumbler to its permanent location. Adjust the leveling legs until the unit is level, or no more than 0.125 inch (32 mm) higher in the front. Refer to Figure 2. Tumbler must not rock. Lock leveling legs with nuts previously installed.

NOTE: The front of the tumbler should be slightly higher than the rear (approximately 0.125 inch,

3.18mm). This will prevent the clothes, while tumbling, from wearing on the door glass gasket.

IMPORTANT: Keep tumbler as close to floor as possible. The unit must rest firmly on floor so weight of tumbler is evenly distributed.

T483I

T483I

Figure 2

Bolt-On Angle Option

50 Pound Tumblers Only

This option allows the tumbler depth to be reduced to 34 5/16 inches. The tumbler should then fit through a 36 inch door opening (actual 34 1/2 inches).

NOTE: Refer to appropriate troubleshooting manual for details on the following procedures.

1.Remove the loading door, access panel, front panel and lint panel. Refer to Figure 3.

34

2

1

5

TMB2014K

TMB2014K

1Loading Door

2Front Panel

3Access Panel

4Cylinder

5Lint Panel

Figure 3

18

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

M414905