Speed Queen TMB796C 23

4.Remove four front panel screws. Refer to Figure 6. Keep door hinge cams in place on door hinge lug. Pull lug and door assembly off as one piece. Refer to Figure 7.

5.Remove remaining front panel screws. four on the top and four on the bottom. Refer to Figure 6. Disconnect door switch harness from switch. Take off front panel. Refer to Figure 7.

6.Exchange switch and plug locations. Depress tabs with an adjustable pliers to remove plug and switch from front panel. Reinstall switch, orienting button toward center of machine. Reinstall plug in switch’s previous location. Refer to Figure 7.

1

3

2

4

5

TMB1995N

1Plug

2Switch

3Side Screw

4Door Hinge Lug

5Door Assembly

Figure 7

Installation

7. Cut wire ties along right side of machine to remove door switch harness from lint panel switch harness bundle. Be careful not to damage harness wires. Refer to Figure 8.

8. Reroute door switch harness up through top panel, along underside of front flange, through screw cable clamp, back down through top panel and into upper left quadrant of cylinder enclosure. Refer to Figure 8.

1

7

2

6

5

3

4

TMB1996N

1Screw Cable Clamp

2Beginning Location of Door Switch Harness

3Original Switch Location

4Lint Panel Switch Harness

5Wire Ties

6Original Plug Location

7Top Panel

Figure 8

M414905

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

21

Contents

Page Page In the U.S.A In Canada In Australia WARNING •WHAT TO DO IF YOU SMELL GAS: –Do not try to light any appliance –Do not touch any electrical switch; do not use any phone in your building –Clear the room, building or area of all occupants Table of Contents Steam Requirements Single Drop Timer Rotary Coin Drop Timer Adjustments Removing Tumbler from Service Introduction Model Identification Introduction Customer Service Wiring Diagram Serial Plate Location Safety Information Save These Instructions Important Safety Instructions Page Specifications and Dimensions Cabinet Dimensions Exhaust Outlet Locations Gas Connection Locations Electrical Connection Locations Steam Connection Locations Installation Pre-InstallationInspection Location Requirements Position and Level the Tumbler Bolt-OnAngle Option Page To Reverse the Loading Door Page Page Before Placing Tumbler into Service Required for CE Models Only Installing CE Gas Drying Tumblers General Information Supply Burner Country Orifice Capacity Basic Configuration Specific Conversion Procedures NOTE: Blank burner orifices are Part No. M400995 Page Exhaust Requirements Layout Make-UpAir Venting Individual Venting Manifold Venting Page Station 8 in. (203 mm) Duct 10 in. (254 mm) Duct Page Gas Requirements Use pipe compound, resistant to actions of L.P. gas, on all pipe threads Gas Supply Pipe Sizing and Looping Equivalent Length 25 feet 50 feet 75 feet 100 feet High Altitude Burner Orifice Sizing Electrical Requirements Grounding Instructions For CE Models Only Service/Ground Location To Connect Electrical Service To The Tumbler Page Jumper Configuration Instructions Ferrite Ring Installation 50 Pound Gas and Steam Models 75 Pound Gas and Steam Models 50 and 75 Pound Electric Models Steam Requirements Piping Recommendations Thermal Oil Prep Steam Pressure PSI (bar) Minimum Pipe Diameter Steam Trap Size (Pounds Condensate/Hour) Single Drop Timer Power-UpMode Ready Mode Start Mode Run Mode Dipswitch Settings Coin Pulse (in Minutes) Rotary Coin Drop Timer Installing Accessory Timing Cam Removal of Existing Timing Cam Installation of New Timing Cam Adjustments Gas Burner Air Shutter Airflow Switch Gas and Electric Tumblers Page Loading Door Switch Loading Door Catch Drive Belt Nonreversing Models Reversing Models Page Page Removing Tumbler from Service