3
5
4
2 
1
6
7
8
TMB2016K
TMB2016K
1Trunnion Housing
2Junction/Contactor Box
3Vertical Trunnion Channel
4Cylinder Pulley
5Drive Guard
6Exhaust Thimble
7Motor
8Motor Bracket
Figure 4
2.Remove the drive guard. Refer to Figure 4.
3.Remove the drive belts. Refer to Figure 4.
4.Remove the cylinder pulley and shaft key.
5.Pull the cylinder out through the front of the tumbler. Refer to Figure 3.
6.To ensure proper cylinder balance for reassembly, mark each channel’s original location on cylinder head and number of shims for each channel before removal. Refer to Figure 5.
7.Remove the complete idler assembly.
8.Remove the trunnion housing. Refer to Figure 4.
9.Disconnect the motor harness(s).
Installation
3 | 4 |
| X |
| 5 |
| 6 |
X | 2 |
| |
2 | 7 |
| |
1 |
|
1 |
|
TMB2015K
1Number of Shims for this Channel
2Cylinder Head
3Trunnion
4Channel Identifier
5Shims
6Channel Location
7Number of Shims for this Channel
Figure 5
10.Remove the motor(s) and motor bracket(s). Refer to Figure 4.
11.Unbolt and remove the two vertical trunnion channels.
12.Remove the junction/contactor box. Refer to Figure 4.
13.Remove the exhaust thimble.
14.The gas supply line may require removal if it extends past the rear panel. If so, disconnect the union located between the gas and shutoff valves and remove the assembly out through the front of the tumbler.
15.Remove the tumbler from the crate base and slide it through the door, sideways.
16.Refer to the appropriate troubleshooting manual, installation manual and wiring diagram to reassemble and install the tumbler correctly.
M414905 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 19 |