Speed Queen TMB796C 24

Installation

9.Place front panel on machine, loosely attach four bottom screws. Connect door switch harness to switch in new location. Install door assembly and four front panel side screws loosely. Refer to Figure 9.

10.Check lint panel fit, adjusting front panel up or down as required. Tighten four front panel side screws to maintain position of front panel for proper lint panel clearance.

11.Remove lint panel. Fully tighten bottom screws on front panel.

12.Reinstall top screws and guide lugs.

13.Adjust door catch if necessary to allow

7 – 15 pounds pull (0.48 – 1.03 bar) at center of handle.

14.Reinstall control assembly using mounting screws.

15.Reinstall control panel and lint panel.

IMPORTANT: Restore power to tumbler and test for proper operation of loading door switch. Tumbler should not start with door open; an operating tumbler should stop when door is opened.

NOTE: If machine is converted back to right hand hinge operation, the door switch harness must be rerouted and rebundled with the lint panel switch harness. Wire ties must be used to secure harnesses. Wire ties (Part No. 55881) can be ordered from RSPC.

1

4

3	2

TMB1997N

1Switch (New location)

2Plug (New location)

3Door Assembly

4Side Screw

Figure 9

22

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

M414905

Contents

Page Page In the U.S.A In Canada In Australia WARNING •WHAT TO DO IF YOU SMELL GAS: –Do not try to light any appliance –Do not touch any electrical switch; do not use any phone in your building –Clear the room, building or area of all occupants Table of Contents Steam Requirements Single Drop Timer Rotary Coin Drop Timer Adjustments Removing Tumbler from Service Introduction Model Identification Introduction Customer Service Wiring Diagram Serial Plate Location Safety Information Save These Instructions Important Safety Instructions Page Specifications and Dimensions Cabinet Dimensions Exhaust Outlet Locations Gas Connection Locations Electrical Connection Locations Steam Connection Locations Installation Pre-InstallationInspection Location Requirements Position and Level the Tumbler Bolt-OnAngle Option Page To Reverse the Loading Door Page Page Before Placing Tumbler into Service Required for CE Models Only Installing CE Gas Drying Tumblers General Information Supply Burner Country Orifice Capacity Basic Configuration Specific Conversion Procedures NOTE: Blank burner orifices are Part No. M400995 Page Exhaust Requirements Layout Make-UpAir Venting Individual Venting Manifold Venting Page Station 8 in. (203 mm) Duct 10 in. (254 mm) Duct Page Gas Requirements Use pipe compound, resistant to actions of L.P. gas, on all pipe threads Gas Supply Pipe Sizing and Looping Equivalent Length 25 feet 50 feet 75 feet 100 feet High Altitude Burner Orifice Sizing Electrical Requirements Grounding Instructions For CE Models Only Service/Ground Location To Connect Electrical Service To The Tumbler Page Jumper Configuration Instructions Ferrite Ring Installation 50 Pound Gas and Steam Models 75 Pound Gas and Steam Models 50 and 75 Pound Electric Models Steam Requirements Piping Recommendations Thermal Oil Prep Steam Pressure PSI (bar) Minimum Pipe Diameter Steam Trap Size (Pounds Condensate/Hour) Single Drop Timer Power-UpMode Ready Mode Start Mode Run Mode Dipswitch Settings Coin Pulse (in Minutes) Rotary Coin Drop Timer Installing Accessory Timing Cam Removal of Existing Timing Cam Installation of New Timing Cam Adjustments Gas Burner Air Shutter Airflow Switch Gas and Electric Tumblers Page Loading Door Switch Loading Door Catch Drive Belt Nonreversing Models Reversing Models Page Page Removing Tumbler from Service