SSI America 601...620 10.1.6 Functional test, 10.1.7 Connection diagram (principle)

10.1.6 Functional test
The functioning of the restart lock must be tested during setup, after every
alteration in the wiring of the system, or after exchanging one or more components
of the system.
1. Stop all drives, with setpoint 0V, disable drives, mechanically block any suspended loads
2. Activate the -AS- option.
3. Open protective screens (but do not enter hazardous area)
4. Pull off the X10 connector from an amplifier:the mains contactor must drop out
5. Reconnect X10. Switch on mains contactor again.
6. Repeat steps 4 and 5 for each individual servo amplifier.
10.1.7 Connection diagram (principle)
Application examples for category 1 see chapter 10.1.8.
94 SERVOSTAR®601...620 Product Manual
Expansions / Accessories 07/2007 Danaher Motion
SERVOSTAR600