SSI America 9210 user manual Passcode and Alarm, IP Address

M4557 - Model 9210 Nitriding Controller

Loop 2 Dec

Loop 2 Combo

PV 3 retrans

Loop 3 Inc

Loop 3 Dec

Loop 3 Combo

Input 1 retrans

Input 2 retrans

Input 3 retrans

Input 4 retrans

The “Offset” selection will allow the user to set the offset. This will display a numeric keypad. This will range from –9999to 9999.

The “Range” selection will allow the user to set the range of the output. This will display a numeric keypad. This will range from –9999to 9999.

Pressing the Esc key returns you to the configuration menu.

Passcode and Alarm

Parameter	Value
Level 1 Code	1
Level 2 Code	2
Web Level 1 Code	111
Web Level 2 Code	222
Web Change Enable	1
No Alarm	Contact is Open
Alarm Text Setup
Alarm 0 – Alarm 99	User Alarm xx

The values shown in the above table are the default values. The parameter “No Alarm” means that if there is NO CONTROLLER ALARM, the controller alarm relay is NO. The “Level 1 Code” and the “Level 2 Code” selections will allow the user to set the Supervisor and Administration passcodes, respectively. Either of these options will display a numeric keypad that will range from 0 to 9999. The “Web Level 1 Code” and the “Web Level 2 Code” selections will allow the user to set the Supervisor and Administration passcodes, respectively, for the 9210’s web page. Either of these options will display a numeric keypad that will range from 0 to 9999. The “Web Change Enable” selection will allow the user determine if changes can be made to the instrument through the web page. This will display a numeric keypad that can be either 1 (Change OK) or 0 (No Change Allowed). The “No Alarm” selection will allow the user to set what the no alarm state is. This will display a numeric keypad that can be either 0 (Contact is Open) or 1 (Contact is Closed). This allows the operator to assign the controller alarm as a NC contact such as a 1400°F alarm. The “Alarm Text Setup” section will allow the user to set the alarm text for up to ninety-nine user alarms. Any of these options will display an alphanumeric keypad.

Press the Esc key to return to the configuration menu.

IP Address

Parameter	Value
IP Address 1	192
IP Address 2	168
IP Address 3	0
IP Address 4	200
IP Address Mask 1	255
IP Address Mask 2	255

SSi Manual SERIES 9210-M4557-Nitriding Page 31 of 31