SSI America 9210 user manual

M4557 - Model 9210 Nitriding Controller

SSi Manual SERIES 9210-M4557-Nitriding Page 1 of 1

Super Systems Inc.

7205 Edington Drive

Cincinnati, OH 45249

513-772-0060, 800-666-4330

Fax: 513-772-9466

www.supersystems.com

SSi’s Nitriding Control System

USER’S MANUAL

Super Systems Inc. help desk:

1-800-666-4330

Contents

Main Super Systems Inc. SSis Nitriding Control System USERS MANUAL Page Page M4557 - Model 9210 Nitriding Controller Safety Symbols Voltage rating Over current protection Earth leakage current M4557 - Model 9210 Nitriding Controller Conductive pollution Routing of wires Installation requirements for EMC Grounding of the temperature sensor shield M4557 - Model 9210 Nitriding Controller NOT Page M4557 - Model 9210 Nitriding Controller Flash Card Installation M4557 - Model 9210 Nitriding Controller SSi requirement: Shutdown Never remove the flash card when the Operator Interface is ON. Page Page M4557 - Model 9210 Nitriding Controller Status Page Page M4557 - Model 9210 Nitriding Controller Passcode and Alarm Page M4557 - Model 9210 Nitriding Controller NOTE: See Sample Recipes at the back of this manual for Recipes 50, 51 and 60. M4557 - Model 9210 Nitriding Controller End of Cycle Page M4557 - Model 9210 Nitriding Controller NOTE: See Chapter 6 of this manual for some sample programs NOTE: A list of Op-Codes appears in Chapter 5 of this manual Program Edit Page Page Page M4557 - Model 9210 Nitriding Controller Warning: Changes to this screen should not be made without consulting SSi at 800-666-4330 M4557 - Model 9210 Nitriding Controller WARNING: This screen should not be changed without consulting SSi at 800-666-4330 SETPT ZONE_OFF Page Page Page Page M4557 - Model 9210 Nitriding Controller Analog Input Setup Page Page M4557 - Model 9210 Nitriding Controller Set Valve do not use M4557 - Model 9210 Nitriding Controller User Calibration Edit Zero Output 1 Calibrate <-- Back Skip Next --> DONE M4557 - Model 9210 Nitriding Controller User Calibration M4557 - Model 9210 Nitriding Controller M4557 - Model 9210 Nitriding Controller Configuration Page M4557 - Model 9210 Nitriding Controller Program Edit for a list of the opcodes Note: See Page Page Page Page Page Page Page Page Page Page Page M4557 - Model 9210 Nitriding Controller Flow Control Boards - These upper limits need to be set in the field for each gas. Limit Switches - Page Page M4557 - Model 9210 Nitriding Controller RS232/485 Communications . 420mAV proportional to 0..100% Hydrogen (minimum load 500 ohm.) Optional Page M4557 - Model 9210 Nitriding Controller Zero=xxx.xx<CR><LF>.command where xxx.xx = 0 (See appendix 1) Page Page Page System errors: M4557 - Model 9210 Nitriding Controller Warning! Important! 5.