SSI America 9210 user manual Alarm Setup, Relay Assignment

M4557 - Model 9210 Nitriding Controller

Alarm Setup

The Alarm Setup menu is a two-level screen. The first level allows you to select the alarm – Alarm1 – Alarm 3. The Second level scrolls through the alarm parameters.

Parameter	Value
Setpoint	2500
Alarm Type	PV2 proc high
Hysteresis	1

Using the lower blue up and down arrow keys, select the parameter to modify, and then press the Enter button. The “Setpoint” selection will allow the user to enter the setpoint for the alarm. This will display a numeric keypad. This can range from –9999to 9999. The “Alarm Type” selection will allow the user to set the type of alarm. This will display a two-level screen. The top level has the following options:

Process High

Process Low

Band, Normally Open

Band, Normally Closed

Deviation, Normally Open

Deviation, Normally Closed

The bottom level has the following options:

PV 1 Value

PV 2 Value

PV 3 Value

Input 1 Value

Input 2 Value

Input 3 Value

PO1 Value

PO2 Value

PO3 Value

The “Hysteresis” selection will allow the user to set the hysteresis. This will display a numeric keypad. This can range from 0 to 9999.

If you are configuring more than one alarm, follow the above instructions for each alarm that you are configuring.

Relay Assignment

This menu selection allows the user to assign the action to the selected Relay Output.

All eight of the 9210’s relay outputs are assigned in this screen. To select a Relay Output to modify, use the up or down arrow keys to highlight the event.

Highlighting the “Assignment” selection that you wish to assign and pressing the Enter button takes you to a screen that has the following choices

•Loop 1 fwd

•Loop 1 rev

•Loop 2 fwd

•Loop 2 rev

•Loop 3 fwd

•Loop 3 rev

SSi Manual SERIES 9210-M4557-Nitriding Page 28 of 28